Description

• Easy operation,competitive cost.positive capacity of cnc working Stable CNC drilling-milling machines with electronic regulation and digital sleeve travel indicator,the contol box is with a big power supply & high subdivision stepper motor driver & pc board of controller,Convincing arguments: quality, efficiency and price

• The perfect CNC control:,Can be learned in short time Rapid, simple setting up of the tools and workpieces Programming supported by cycles and contours Simple drive link-up with step-by-step technique.Complete unit with little dimensions

• X, Y, Z axis are all updated with ball screws, including two screw nuts, plane bearing and couplers. All these will provide very high localization accuracy. It has two 23 high speed stepper motor for X, Y axis and a big moment 34 one for Z axis.

• The 34 stepper motor are smartly installed in the base of the machine, it has the direct link to the Z ball screw with a coupler. This installation has better accuracy than other conversion plans. What’s more, it will not take extra room to influence the installation of the back shell.

• All the stepper mounts, ball screw mounts are made of steel, by wire cut machines. So they have good size precision and best rigidity than other plans which using aluminum materials.

• The X, Y axis steppers, we made shells to protect them from fritters. Of course, the Z axis stepper does not need a shell, it is completely hidden inside, and we can’t see it after installation at all.

• Photocouplers are installed in every axis as the limit/origin check switch. They have very good accuracy to set up a machine coordinate system just like real industrial machines.

• For the NC system power supply, we have two 300W switch powers to supply the three stepper motors. Two 23 motors of X, Y axis use one together and the 34 motor use one singly. So the power system provides quite enough power to hard work.

• For the NC control system, including CNC interface board, three stepper drivers, provide quite all-around functions such as STEPPER FREE, EMERGENCY STOP, LIMIT/TOOL ADJUST SENSORS, SPINDLE CONTROL, HALF DRIVE CURRENT, OVER-THERMAL PROTECTION, etc. About its performance, it provides subdivisions up to 100, the performance even near to a servo system. We recommend you use the system with upper software such as MACH (we think the best), KCAM4.

• All the power supplies, NC control systems are all integrated to the back shell, so the total machine looks still very compact. You don’t need to have a extra control box or power supply at all, just turn on the power switch of the mill, all the NC function will start together. Joint the interface connector on the shell and your PC parallel interface with a cable we offered, you can enjoy the CNC mill so easy!

• To strengthen the heat sink of the electronics in the back shell, we add a 12CM fan on the shell to cool them. So you don’t need to wary about the stability when summer.

• All exposed wires are covered by plastic corrugated pipes to make the machine looks cool. A switch is set to the position where the Z axis hand wheel has been. You can use it as coolant switch or FREE, or EMERGENCY STOP.

• At last, maybe you have seen on the first sight, we installed a 3D bracket with a tray on it. The bracket can be localized at any height, position it can reach, and the tray can be turned 360°. You can place your notebook PC or monitor on it, which is very useful for work (we recommend you do this, try it). Of course, you can place tools, blueprints, coffee etc. on it. You will find the advantages when work.